RC Sim Community
 
HomeCalendarFAQSearchMemberlistUsergroupsRegisterLog in

Share | 
 

 Using DX 8 with Pheonix 5

View previous topic View next topic Go down 
AuthorMessage
bosan



Posts : 1
Join date : 2015-07-29

PostSubject: Using DX 8 with Pheonix 5   Wed Jul 29, 2015 4:11 pm

Hi everyone. Newbe here with a question. I have my DX8 set up on Pheonix 5 and have been flying a park zone glider with no problem. I changed models to a Blade 350QX quad and have enjoyed flying it and even trimming it to hover.

My question is how do I trim the motor control ? In full idle, the 350QX only hovers just above the ground and I can't land it. It takes off from the ground at startup just fine.

Thanks
Back to top Go down
View user profile
 
Using DX 8 with Pheonix 5
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» High Elf Army For Sale
» OTTAWA PHOENIX BASKETBALL TEAM TRYOUTS 2015

Permissions in this forum:You cannot reply to topics in this forum
PhoenixRC Forum :: General :: Phoenix 5 General-
Jump to: